![]() ![]() The Maestro RR also gives you the option to turn off the OEM UConnect, Bluetooth, and satellite. Before installing the Maestro RR, it needs to be flashed with the firmware so it can interface between the OEM connection cables and the stereo. This mod is completely covered by the dash panel and cannot be seen was the front panel is in place). Basically, it was a straight swap with a little modification needed (had to open the hole a little at the top and bottom so the AVIC would slide into place. Last weekend I installed the Pioneer AVIC. I found it a couple hundred bucks cheaper on Amazon. I ordered everything needed from Crutchfield except the Pioneer AVIC. The Maestro RR allows you to interface UConnect and the steering wheel button with Pioneer AVIC system. I settled on the new Pioneer AVIC-8200 NEX receiver along with the iDatalink Maestro RR. I went this route because I wanted to keep the UConnect.Ī couple of weeks ago I decided it was time to upgrade the receiver so I started researching what was available. The DQ-61 takes the signal from the OEM receiver and turns it into a pre-amp output which then goes to the amp. A sub box for a 10" kicker was built to fit under the rear storage compartment door and a JL Audio amp and Audio Control DQ-61 processor. The front speakers were replaced with 6x9 Focal components and the rear door speakers were replaced with Focal 6.5 coaxial speakers. ![]() A year or so ago I had a system installed that utilized the OEM RHR receiver. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |